* Standard Time: Eco Mode → Over 225min, Speed: Over 180min
* Drying Condition: Cotton-Cupboard, 9kg Cotton Clothes, Spin rpm: Over 1,000rpm
Measurement condition : Check if they are working while being connected to power supply.
Is the product leveled? (Check shaking / tilt )
3) Is it installed to Built in / Under environment?
Improve dryer installation
environment.
(Refer to installation environment,
Page 10~12)
1.Check resistance
2.Check harness & connection.
1. Is OLP normal?
2. Is Comp resistance normal?
3. Is capacitor resistance normal?
(refer to page 16)
4. Is LEV resistance normal?
5. Check trace of oil leakage around Comp.
( Refer to humidity sensor inspection
method, Page 30 )
Does the defect occur after PCB
replacement ?
2.For Comp defect
-. Replace Comp
(Refer to R code - C145 , Page 45)
3. For LEV defect
-. Replace LEV.
4) After Comp on, check corresponding
thermistor temp.
Release thermostat trip or replace thermostat.
Replace heater or repair connection.
Leg leveling
(Refer to how to leveling, Page 10)
NO The course Show details
1
2
3
4
5
6
7
8
9
10
11
12
Refresh
Skin Care
Jeans
Bulky Item
Easy Care
Mixed Fabric
Cotten
Sports Wear
Quick Dry
Delicate
Wool
Rack Dry
Humidity values
Low Temp
Comp Temp
T_heater (High Thermistor)
Eva in Temp
Sump Water Level
Drain Pump RPM
LEV Pulse
Main PGM Tool
Main Version
※Check the status of the actions Sensor
- Drum Light + Buzzer 3 when entering Pressing enter,
Once again press the same key fot three seconds
to escape.
- Turn the Jog Dial in data view state data can be
checked as shown below.
- Not to enter the Child lock status.
- Apply the model : Only Touch LED model.
To Next Page
Loading...
Need help?
General
