LG RC90V9JV2W User Manual

14
INSTALLATION
WARNING
• The weight of the appliance and the height of the
installation makes the installation procedure too
risky for one person.
• Incorrect installation can cause serious
accidents.
• Do not operate if the appliance is not properly
stacked.
NOTE
• The stacking kit should be aligned depending on
the depth of the washing machine. (When you
open the door or look at the side of the washing
machine, you can find the dimension
information of your washing machine at the
label.)
• For
Type A , it must be assembled with 550R or
550L on upper part.
• For
Type B , it must be assembled with 600R or
600L on upper part.
*1 The depth of the washing machine
1 Place the appliance on the top of an LG front
load washing machine.
2 Remove the 2 screws from the bottom of the
rear cover on each side.
3 Align the LG stacking kit holes and the rear
cover holes in a line.
• In case of that the depth of the washing
machine is 550 mm or more and 599 mm or
less
• In case of that the depth of the washing
machine is 600 mm or more and 650 mm or
less
4 Fasten the 2 screws that were removed earlier
from the appliance to the stacking kit.
5 Use the 4 screws in the accessory box (16 mm)
to assemble the washing machine rear cover
and stacking kit.
6 The procedure for the opposite side will be the
same.
How to align LG stacking kit to the appliance
Type A Type B
550 mm 1 the
depth
*1
1 599 mm
600 mm
1 the
depth
*1
1 650 mm

LG RC90V9JV2W Specifications

General

Brand	LG
Model	RC90V9JV2W
Category	Dryer
Language	English