27
MAINTENANCE
ENGLISH
Cleaning the PM1.0 Sensor
• This process is applicable only when the air
purifying front panel is installed.
- PM1.0 Sensor is only included with air
purifying front panel.
• It is recommended to clean the PM1.0 sensor
every 6 months.(assuming 8 hours of daily use)
- Cleaning interval is set period assuming that 8
hours of daily use.
• Turn off the power to the appliance before work.
• Be careful not to drop the product when
removing the PM1.0 Sensor corner cover.
• Be careful of falling accidents when cleaning the
PM1.0 sensor.
1
Remove the dust sensor corner cover
a
on the
front panel.
2
After opening the PM1.0 sensor cover
b
,
remove the rubber cover
c
.
3
Wipe off any dust adhering to the lens using a
cotton swab slightly moistened with water.
Then wipe again with a dry cotton swab to
remove moisture.
4
After inserting the rubber cover
c
, assemble
the PM1.0 sensor cover
b
.
5
Assemble the dust sensor corner cover
a
on
the front panel.
Tips for Maintenance
Before Long Periods of Disuse
1
Operate the air conditioner in the
Fan mode
for 2 to 3 hours.
To Next Page
Loading...
