8
ENGLISH_index
Before Installation
(Except for LSW440B)
• Do not use the product for any purpose other than installing the
TV on a wall.
• Avoid product damage and safety accidents caused by careless
installing or use of improper or unauthorized wall mount.
• Follow the instructions in the installation manual for a convenient
installation of the wall mount.
• Immediately discontinue installation and contact the service centre
if you cannot fully understand the installation process.
Use a professional installer if any installation issues remain after
the inquiry.
• Installation of this product on a concrete wall is recommended.
Installation of this product on other surfaces (walls made of wood,
plywood, bricks, etc.) is not recommended. Improper installation
may result in the product falling.
• Install the product only on a vertical wall.
Do not install on a tilted wall that exceeds building standards or on
the heavily titled wall or ceiling.
LG is not responsible for problems caused by improper installation
of the product, e.g., heavily tilted walls and ceilings.
• Check the enclosed accessories before installation. We are not
responsible for any lost or damaged accessories after the inner
packaging is opened.
• When an infant or small child swallows the enclosed accessories,
various safety accidents such as choking may occur. Keep the
enclosed accessories out of the reach of infants and children.
• When tightening screws, tighten until fully snug.
Avoid using excessive force when tightening the screws. Doing
so may damage the wall and product or reduce the rigidity or
performance of the product.
• Avoid installing a TV that exceeds the specied tensile load, and do
not allow any external force to be applied to the product.
• Avoid accidents by using work tools with care during installation.
Tools for Installation
• "+" shaped screwdriver (manual or electric) / 8mm wrench / level
/ drill / Ø8mm drill bit for concrete or Ø4mm drill bit for steel
Securing TV to the Wall
(Except for LSW440B)
• Please use the TV close to the wall after installation.
How to x anchors and screws
(Except for LSW440B)
Please make sure that:
• Check that the material and thickness of the wall and nishing
material comply with the installation manual.
• Use the enclosed anchors and screws on crack-free concrete walls.
• Never install the product on a wood stud, plasterboard or wall
made of paper or medium-density berboard (MDF). When it
is necessary to install the product on such wall, anchor screws
must be fastened to retaining walls (concrete) inside the nishing
material, and if there are no retaining walls, anchor screws must be
fastened after a separate hanger is installed.
• Other unspecied walls must be capable of supporting pullout
loads of over 70kgf (686N) and shear loads of over 100kgf (980N)
per fastener.
• Use a Ø8mm drill bit and hammer (impact) drill for concrete.
To Next Page
Loading...
Need help?
General
