LG SolarDOM - Page 44

44
Rotisserie
Installation & Cooking
To Clean ROTISSERIE &
METAL TRAY
When cooking is completed,
separate the ROTISSERIE from
the food. Take care when
handling ROTISSERIE, metal
tray and food stuff as it is very
hot. During cooking it is normal
for the ROTISSERIE & metal
tray to be stained from the
food. Simply clean the
ROTISSERIE & metal tray with a
warm soapy water and a soft
cloth. If the ROTISSERIE &
metal tray remain stained after
washing, soak utensils in hot
soapy water for a few minutes.
Do not use metal scouring
pads. They will scratch the
surface .
Insert the shaft of right
plate into the shaft of
motor.
Press START/Q-START.
After cooking, hold the rotisserie bar of both side with the handle and lift up
the left end lightly and pull out from the right end.
NOTE:
1. The rotisserie cooking is convenient for grilling of meat and poultry.
All the surface of the food will become even brown without overturning.
2. The rotisserie cooking can be used in Grill mode, Convection mode and
Gourmet delight mode.
3. The rotisserie bar is used for rotisserie cooking only. After rotisserie cooking is
finished remove the rotisserie bar and store with other accessories.
CAUTION
1. DO NOT USE THE ROTISSERIE WITH NO LOAD, IT WILL DAMAGE THE OVEN.
2. AFTER COOKING, THE METAL TRAY WILL BECOME EXTREMELY HOT.
3. It is recommended to remove the grease from the turntable every time before
cooking. Hot grease on the turntable may cause smoke.
The shaft of motor
The holder of Rotisserie
Put the shaft of left plate on the
holder of rotisserie.
Metal Tray
HANDLE