53
Mounting the Product to a Wall
Checking before mounting to a wall
You can mount this product onto a wall.
When affixing the product to the wall, follow the instructions below.
Please check the following first.
• It may be difficult to connect external devices and cables after wall-mounting. First, connect an
external device with the proper connection cable to the product before mounting it to the wall.
• Please note the following when you mount the product to the wall. Product damage or injury
may occur during the process.
- Do not put objects on top of the wall-mounted product.
- Secure the product firmly to the wall using the fixing screws so that it does not fall off.
- Ensure it is out of the reach of children. Pulling or shaking the mounted product may cause it
to fall.
• Do not use the wall mount bracket for any purpose other than installing the soundbar on a wall.
• Immediately discontinue installation and contact the service center if you cannot fully
understand the installation process. Use a professional installer if any installation issues remain
after the inquiry.
• Installation of this product on concrete wall is recommanded. Installation of this product on
other surfaces (Wood Stud, dry wall, plywood, bricks, etc.) is not recommanded. Improper
installation may result in the product falling.
• Install the product only on a vertical wall. Do not install on a tilted wall that exceeds building
standards or on the heavily titled wall or ceiling. LG is not responsible for problems caused by
improper installation of the product, e.g., heavily tilted walls and ceilings.
• Check the enclosed accessories before installation. We are not responsible for any lost or
damaged accessories after the inner packaging is opened.
• When an infant or small child swallows the enclosed accessories, various safety accidents such
as choking may occur. Keep the enclosed accessories out of the reach of infants and children.
• When tightening screws, tighten until fully snug. Avoid using excessive force when tightening the
screws. Doing so may damage the wall and product or reduce the rigidity or performance of the
product.
• Avoid installing the unit that exceeds the specified tensile load, and do not allow any external
force to be applied to the product.
• Avoid accidents by using work tools with care during installation.
• Because it is difficult to make a connection after installing this unit, you should connect the
cables before installation.
• When assembling, ensure that all of the provided screws are attached. If the screws are not
fully tightened, the product may tilt or tip over, resulting in damage. Tightening the screws with
excessive force may cause them to come off due to abrasion of the screw joint.
Mounting the Product to a Wall
To Next Page
Loading...
Need help?
General
