LG Styler S3RERB - Page 15

15
3 Place the adhesive side of the non-skid
pad on the floor.
4 Recheck the Styler's levelness.
Push or rock the edges of the appliance
gently to make sure that the Styler does not
rock. If the Styler rocks, level the appliance
again.
• The pads may leave a sticky residue when
they are removed. The residue can be
removed with alcohol.
INSTALLING THE ANTI-TIP DE-
VICE
• Appliances can tip, resulting in damage or
injuries. Do not operate the unit without
the anti-tip device in place and engaged.
If an anti-tip device is not properly installed,
the appliance could be unexpectedly tipped
by a child or adult standing, sitting, leaning, or
placing excessive weight on an open door or
the interior parts.
• Install the anti-tip device packed with the
Styler to reduce the risk of tipping.
Refer to the instructions provided with the anti-
tip kit for proper anti-tip device installation.
• Check that the anti-tip device is properly
installed.
With the appliance in its final location, make
sure that the slide adjuster on the cord is
adjusted until there is about one inch of slack
in the cord.
• The use of the anti-tip device does not
preclude tipping of the appliance when it is
not properly installed.
ASSEMBLING THE DRIP TRAY
Before using the Styler, insert the drip tray onto
the bottom of the cabinet.
1 Holdthetraysothearrowandletteron
thefrontofthetrayfaceup.
2 Insertonesideofthetrayrst,then
theother.Pushthetrayuntilitslides
completelyin.
3 Todetach,pullonesideoutthentheother.
If the tray collects water, detach it and empty
the water. After emptying it, re-assemble the
tray.
• Do not operate the Styler without
installing the drip tray. Doing so could lead
to water damage caused by leaking.
INSTALLING CAP COVERS
1 Lineupthenubsonthecap
withtheholesinthetop
cornerofthecabinet.
2 Snapthecapintoplace.
Repeatwiththeremainingcap
ontheothercorner.
INSTALLING HINGE
COVERS
1 OpentheStylerdoor.
2 Snapthehingecoverwiththebentedge
ontothelowerhingeassembly.
3 Snaptheremaininghingecoverontothe
upperhingeassembly.
Remove
backing
This side up
Adhesive
side
Top Assembly
Lower Assembly