LG Styler S3RERB - Page 72

72
12-4. When Door Open LED is blinking
Is the front filter clogged with water film or
foreign substances?
Is the magnet present inside the holder at the top of the door?
Is the reed switch connector (BL2) connected?
Is the gasket of the door properly assembled?
(check if it is not assembled or is removed.)
Remove the foreign substances and water film.
 Clean the filter as needed.
Insert the magnet and check again.
Connect the connector.
Assemble the gasket and check again.
Does the product move a lot when you shake it?
※
Check if the floor is level.
Is the front/rear vent clogged with clothes when you open the door?
Adjust the legs to make the product level and
check again.
Remove the clothes and check again.
YES
YES
YES
NO
NO
NO
NO
NO
YES
YES
YES
NO