AD5235
25
2 Basic Functions
TTuurrnniinngg tthhee PPhhoonnee OOnn aanndd OOffff
TTuurrnniinngg tthhee PPhhoonnee OOnn
1)
Install a charged battery pack or connect the phone to an
external power source such as the cigarette lighter
charger or carkit.
2) Hold down the Key for 2 seconds until the LCD
screen flashes.
NOTE As any other communication device, avoid
any unnecessary contact with the antenna
while your phone is turned on.
TTuurrnniinngg tthhee PPhhoonnee OOffff
1) Press and hold until display screen turns off,
then release the key.
SSiiggnnaall SSttrreennggtthh
The quality of a call depends on the strength of the
signal supplied by the operator. The phone shows its
signal strength through bars, located at the left top of the
screen. If there are more bars (a maximum of six), the
phone holds more signal strength. If the signal strength
is not satisfactory, try to change the position of the
phone. If you are in a building, try to be near to a window,
where the reception of the signal may be better.
In some places such as : tunnels, elevators, basements
and garages, there may be limitation of the signal
supplied by the operator.
BASIC FUNCTIONS
To Next Page
Loading...
