System Set-Up
86 Air-to-Water Heat Pump
1
Keep pressing programming button for 3 seconds to enter setting
screed drying mode.
2
Press programming button to select
function code 18.
3
Press left, right button to move to
screed drying setting part.
4
Press up, down button to adjust “01” or
“00”
(00: Not Used 01: Used)
5
If you finish the setting,
press OK / CLEAR button.
6
Press exit button to exit or system will automatically release without any
input 25 seconds.
7
During the screed drying mode, “dry” is
displayed.
Left days for completing the screed drying
mode are displayed.
To Next Page
Loading...
