LG UltraGear 32GS95UE

21
ENGLISH
[General]
[Settings] > [General]
• [Language]: Sets the menu screen to the desired language.
• [OLED Screen Move]: Moving the screen minutely at regular intervals helps to prevent panel noise caused by
images that have been fixed for a long time.
Supports four modes with different screen movement paths, pixel counts and cycles. Select the appropriate
mode in accordance with the usage environment.
• [OLED Screen Saver]: If there is no movement on the screen for a certain period of time, the screen turns off
automatically.
• [OLED Image Cleaning]: Corrects screen problems that may occur when the monitor is turned on for a long
time. This will take approximately 10 minutes to complete.
It is automatically executed when entering power saving mode or turning off the power after more than 4
hours of use from the previous [OLED Image Cleaning] completion.
• [Hexagon Lighting]: Sets the lighting on the back of the monitor.
- [Static 1], [Static 2], [Static 3], [Static 4]: Sets the lighting to the desired color.
- [Cycling]: All colors appear alternately.
- [Off]: Turns off the light on the back of the monitor.
• [User-defined Key 1]/[User-defined Key 2]: You can customize the main menu to access your preferred menu
easily. [User-defined Key 1] and [User-defined Key 2] appear at the left/right of the main menu.
• [SMART ENERGY SAVING]: Conserve energy by using luminance compensation algorithm.
- [High]: Saves energy using the high-efficiency [SMART ENERGY SAVING] feature.
- [Low]: Saves energy using the low-efficiency [SMART ENERGY SAVING] feature.
- [Off]: Disables the feature.
- The value of energy saving data may differ depending on panel and panel suppliers.
- If you select the option of [SMART ENERGY SAVING] is [High] or [Low], monitor luminance become higher
or lower depend on source.
• [Deep Sleep Mode]: When [Deep Sleep Mode] is [On], power consumption is minimized while the monitor is
in standby mode.
• [Automatic Standby]: If there is no operation on the monitor for a certain period of time, the monitor will
automatically switch to standby mode.
• [Input Compatibility Version]: You can set each input to match the supported version of the connected device.
- If the connected device supports 2.1 in HDMI but the screen or sound does not work properly, set this
function to 2.1(AV).
• [Buzzer]: This feature lets you set the sound generated from Buzzer when your monitor powers on.
• [OSD Lock]: This feature disables the configuration and adjustment of menus.
All features are disabled except:
- [Brightness] / [Contrast] in [Picture Adjust]
- [Volume] in [Sound]
- [Input]
- [OSD Lock] / [Information] / [Open Source Software License] in [General]
• [Information]: The following display information will be shown; [Total Power On Time], [Resolution].
• [Open Source Software License]: If you select the [View], you can check the Open Source Software notice
information.
• [Reset to Initial Settings]: Returns to the default settings.