INSTALLATION
11
ENGLISH
Precautions in bending
1
If it is necessary to bend or stretch the tubing, use the spring which is attached to the tubing
instead of pipe bender.
- Please make a careful notice to make a smooth line.
- Hold the tubing with your two hands closely and then bend or stretch it slowly not to make
any crack.
- Remember that the radius (R) should not exceed 70mm (Refer to Fig. 1)
2
Do not repeat the bending process to prevent the tubing from cracking or crushing.
3
Keep in mind that the bending part should not be cracked and make the radius (R) as long as
possible (Refer to Fig. 2)
Spring
R70mm
(Fig. 1)
(Fig. 2)
R
To Next Page
