LG UR76 Series - Control and Fail Over Commands; Backlight, Input Select, Fail Over Commands

ENGLISH
79
21 Control Backlight (Command: m g)
► To control the backlight.
Transmission
[m][g][ ][Set ID][ ][Data][Cr]
Data Min : 00 to Max : 64
Ack
[g][ ][Set ID][ ][OK/NG][Data][x]
22 Input select (Command: x b) (Main Picture Input)
► To select input source for main picture.
Transmission
[x][b][ ][Set ID][ ][Data][Cr]
Data Structure
MSB LSB
0 0 0 0 0 0 0 0
External Input Input Number
External Input Data
0 0 0 0 DTV
0 0 0 1 Analogue
0 0 1 0 AV
0 1 0 0 Component
0 1 1 0 RGB
0 1 1 1
HDMI
1 0 0 0
1 0 0 1
1 0 1 0
Input Number Data
0 0 0 0 Input1
0 0 0 1 Input2
0 0 1 0 Input3
0 0 1 1 Input4
Ack
[b][ ][Set ID][ ][OK/NG][Data][x]
23 Fail Over Mode (Command: m i)
► Selects the Fail Over mode.
Transmission
[m][i][ ][Set ID][ ][Data][Cr]
Data 00 : Off
Data 01 : Auto
Data 02 : Manual
Ack
[i][ ][Set ID][ ][OK/NG][Data][x]
24 . Fail Over Input Select (Command: m j)
► Selects an input source for fail over. (This feature is only available when
Fail Over is set to Custom.)
Transmission
[m][ j][ ][Set ID][ ][Data1][ ][Data2][ ][Data3][ ][Data4]… [ ][DataN][Cr]
Data 1-N (Input priority 1-N)
Data 20: AV1
Data 21: AV2
Data 22: AV3
Data 90: HDMI1
Data 91: HDMI2
Data 92: HDMI3
Data 93: HDMI4
Ack
[j][ ][SetID][ ][OK/NG][Data1][Data2][Data3][Data4]… [DataN][x]
* Some input signals may not be available for all models.
* The data number (N) may vary depending on the model. (The data
number depends on the number of supported input signals.)