ENGLISH
34
Clock Setup
(Depending on model)
Clock Display
(Depending on model)
• You can select ‘Enable’ or ‘Disable’.
• After selecting ‘Enable’, you can see the LED Clock TV.
Dimming Standby
(Depending on model)
• Standby Dimming value Range : 1~2
Dimming PowerOn
(Depending on model)
• PowerOn Dimming value Range: 1~5
Clock Source
• You can select ‘O ’, ‘Pro:Centric’, ‘TV’, ‘NTP’, ‘Admin’.
• NTP : Clock is synchronized using Network Time Protocol. It’s only enabled when network cable is connected.
• Admin : It’s automatically set to Admin when clock is updated by commercial protocols like TVLink-HCEC, TVLink-Interactive, or HCAP API.
• O : Clock is synchronized using any available clock source.
• Pro: Centric : Clock is synchronized using Pro:Centric server. (Depending on model)
• TV : Clock is synchronized using particular TV channel.
-
Input (Depending on model)
» You can select 'Input' according to 'Clock Source'.
» You can select 'RF' or 'IP' when Clock Source is 'Pro:Centric'.
» You can select TV source when Clock Source is 'TV'.
» Input is set to 'None', 'HCAP', 'Protocol', 'HTNG' automatically when Clock Source is 'Admin'.
-
Channel / Frequency (Depending on model)
» Sets the Frequency to get the time information when Clock Source is 'Pro:Centric'.
» You can select channel when Clock Source is 'TV'.
-
Timezone (City) / Timezone (Custom) / Timezone (Offset) (Depending on model)
» In the case when there is difference between the time information received from the Teletext and the time of the current area, it can
be set up to correct this. The initial value is 0, and it can be changed in the range of -12 Hrs ~ +14 Hrs. (Timezone (Offset) range is -12
Hrs ~ +12 Hrs)
Password Change
• To ensure more security, Password can be changed by installers’ own design.
1 Change password by using virtual keyboard.
2 Input the password again for conrmation.
Lock Mode
• If ‘Lock Mode’ is ‘Yes’, the following features will be unavailable.
USB
• If it is set to ‘Enable’, USB devices do not work in relative features. (Exclude S/W update)
Factory Reset
• If it is set to ‘Enable’, User Menu General Reset to Initial Settings is disabled.
To Next Page
Loading...
Need help?
General
