15
HOW TO START AND STOP CLEANING
After the HOM-BOT is turned on, press the START/STOP button to
begin cleaning. A melody will sound and cleaning will begin.
Press the START/STOP button during the cleaning cycle to stop cleaning.
※ When the ‘START/STOP’ button is pressed while the power supply
of the HOM-BOT is turned off, the power will be turned on. Press the
‘START/STOP’ button one more time to start cleaning.
After the HOM-BOT is turned on, press the START button on the re-
mote control. A melody will sound and cleaning will begin.
Press the STOP button during the cleaning cycle to stop cleaning.
※ The HOM-BOT cannot be turned on from Stand By, by using the
remote control when the power of the HOM-BOT is off. When the
power is off, press the ‘START/STOP’ button on the upper side
of HOM-BOT to turn the power on and to allow the remote to be
used.
※ When the START button on the main unit or remote control is pressed, HOM-BOT will start cleaning in
‘Spatial expansion’ mode.
※ During cleaning, collisions can happen when the sensor cannot detect objects because of their shape.
When this happens, the internal impact detecting sensor will activate and engage a backward motion.
※ If the HOM-BOT is set to start cleaning at a location away from the home station, put the device on a flat
floor in order to prevent a malfunction of the obstacle detecting sensor. In addition, start cleaning from a
location where there are no obstacles such as curtains or walls within 30 cm (11.8 in) of the HOM-BOT.
Using the buttons on the HOM-BOT
Using the remote control
For best results:
• Briefly scan the area to be cleaned for big and small objects that may cause difficulty for the
HOM-BOT.
• If cleaning is started when the HOM-BOT is at the home station, the device can rapidly be re-
turned to the home station as the current home position has been accurately read.
Tip
ENGLISH
To Next Page
Loading...
Need help?
General
