21
MOP CLEANING
1. Attach the ultra microfiber mop to the Velcro
of the mop plate as shown in the figure.
※ To prevent the HOM-BOT from malfunction-
ing, attach the mop so that the mop attach-
ing guide will not be covered by the mop.
2. Accurately match up and insert the mop plate
fixing hook on the lower section of the HOM-
BOT into the fixing groove of the mop plate.
3. When you accurately match up and press the
mop plate to the rear side of the HOM-BOT, it
will mount with a clicking sound.
※ Be careful to properly mount the mop plate,
or it can separate during cleaning.
For mop cleaning, mount the mop and mop plate to the HOM-BOT according to the following instructions:
Attaching
guide
Mop plate
Mop fixing section
Ultra microfiber mop
With mop attached
By attaching the ultra microfiber mop, you can ef-
fectively use the HOM-BOT to remove dust.
When the mop plate is attached, the HOM-BOT will
not climb on to carpets or over thresholds, in order to
prevent transferring dirt from the mop.
• To avoid odors, wash any foreign material or dust off the mop after cleaning is complete.
• To avoid staining floors, do not use the ultra microfiber mop to clean when dirt is mixed with
liquids such as coffee or ink.
• To avoid damage to carpets from the Velcro or dirt transfer from the mop, do not clean the
carpet while the mop plate or mop is attached.
• Keep the ultra microfiber mop dry. Do not use it on wet surfaces.
Ultra microfiber mop
Mop plate
Ultra microfiber
Fixing hook
Fixing groove
"Click"
Tip
ENGLISH
To Next Page
Loading...
Need help?
General
