26
OPERATION
Restoring the Previous Settings
When the air conditioner is turned on again after a
power failure,
Auto Restart
function restores the
previous settings.
When using the appliance for the first time,
Auto
Restart
function is set. You can cancel and set this
function by pressing the
POWER
button
a
on the
indoor unit.
Cancelling Auto Restart
1
Open the up-down vane (Type 1) or front cover
(Type 2).
2
Press and hold the
POWER
button
a
for 6
seconds.
3
When the appliance beeps twice, release the
POWER
button
a
. The lamp will flash twice.
This repeats 4 times.
Setting Auto Restart
1
Open the up-down vane (Type 1) or front cover
(Type 2).
2
Press and hold the
POWER
button
a
for 6
seconds.
3
When the appliance beeps twice, release the
POWER
button
a
. The lamp will flash. This
repeats 4 times.
Type 1
Type 2
• The feature may change depending on the
model type.
• If you press and hold the
POWER
button
a
for 3
– 5 seconds, instead of 6 seconds, the appliance
will switch to the test operation. In the test
operation, the appliance blows out strong
cooling air for 18 minutes and then returns to
factory default settings.
To Next Page
Loading...
