Connecting with the PC
1, Before setting up the monitor, ensurethat the power to the monitor, the computer
system, and other attached devices is turned off.
2, Connect signal input cable @ and power cord @ in order, then tighten the screw
ofthe signal cable.
Q Connect D-sub(Analog signal) Cable
Variesaccordingto model.
When using a D-Sub signal input cable connector for
Macintosh
MAC
Mac adapter : For older Apple Macintosh use,
a separate plug adapteris needed to change
the 15 pin high density (3 row) D-sub VGA
connector on the supplied cable to a 15 pin 2
row connector.
Wall-outlet type
PC
3, Press the power button on the front panel to turn the power on. When monitor power is
turned on, the 'Self Image Setting Function' is executed automatically.
Power Button
0
To Next Page
Loading...
