Connecting with the PC
1, Before setting up the monitor, ensure that the power to the monitor, the computer
system, and other attached devices isturned off.
2, Connect signal input cable @ and power cord O in order, then tighten the screw
of the signal cable.
Q Connect D-sub(Analog signal) Cable
Connect DVI-D(Digitalsignal) Cable
Variesaccordingto model.
Wall-outlet type
f
When using a D-Sub signal input cable connector
for Macintosh
MAC
Mac adapter : For older Apple Macintosh use,
a separate plug adapter is needed to change
the 15 pin high density (3 row) D-sub VGA
connector on _e supplied cable to a 15 pin 2
row connecto_
PC
PC
DVI-D (This feature is not available in all countries.)
3, Press the power button on the front panel to turn the power on. When monitor power is
turned on, the 'Self Image Setting Function' is executed automatically.
(Only Analog Mode)
Power Button
0
To Next Page
Loading...
