66 MAINTENANCE
4 After 1 hour 43 minutes of descaling, a popup
will appear in the display. Following the
instructions, drain the tank and fill it with
clean water.
5 Insert the tank and start the Rinsing function.
6 Once the Rinsing function is complete, dry the
inside of the oven with a soft cloth. Leave the
oven door open and allow the oven to dry
completely.
• The Rinsing function must be completed even if
the Descaling function is canceled.
• If water remains on the oven bottom after
descaling, it can leave a residue after the oven is
used. To remove the residue, see the
instructions under "Cleaning Scale on Oven
Bottom."
• After running the Descaling function, clean the
steam feeder tank.
Drying the Lower Oven Interior
The Drying function removes residual water inside
the steam generator. The function takes a little
over 1 minute and runs automatically after any
steam cooking cycle. The Drying function can also
be started manually, if needed.
Setting Drying
1 Make sure that the steam feeder tank is
empty.
2 Touch Clean in the Cooking Modes screen.
Touch Steam Maintenance and Descaling in
that order.
3 Touch Start to begin Drying. The remaining
time appears in the display.
Using Evaporation Function (Lower
Oven)
Use the Evaporation function to dry the oven cavity
after a steam cooking cycle. Evaporation runs for
12 minutes.
Setting Evaporation
1 Touch Clean in the Cooking Modes screen.
Touch Steam Maintenance and Evaporation
in that order.
2 Touch Start to begin Evaporation. The
remaining time appears in the display.
Periodic Maintenance
Changing the Oven Light
The oven light is a standard 25-watt halogen bulb
for ovens.
• Make sure that the oven and bulb are cool.
• Disconnect the electrical power to the appliance
at the main fuse or circuit breaker panel. Failure
to do so can result in severe personal injury,
death, or electrical shock.
• Wear gloves while changing the oven light. Glass
fragments from broken bulbs can cause risk of
injury.
• Gently twist the screwdriver blade while
changing the oven light. If you apply force, the
glass or oven may crack.
1 Unplug the oven or disconnect power.
2 Remove the oven racks.
3 Slide a flat blade screwdriver a between the
housing and the glass light cover
b.
4 Support the glass light cover with two fingers
to prevent the cover from falling to the
bottom of the oven.
5 Gently twist the screwdriver blade to loosen
the glass light cover
c.
us_main.book.book Page 66 Friday, December 3, 2021 2:25 PM
To Next Page
Loading...
Need help?
General