LG WD-10480 - Clean the Drain Pump Filter; Pulley;Motor;Damper

28
①①
Remove the back cover.
②②
Take off the belt turning the pulley.
③③
Unscrew the bolt to pull out the pulley.
①①
Unscrew 2 screws from the bracket.
②②
Push the motor in the arrow direction for
disassembling.
③③
When reassembling the motor, make sure that motor
mounting bushings are not taken off from the bracket.
①①
Pull out the hinge, pressing its snap.
②②
Do not use the pulled - out hinge again. It may be
taken off during operation.
Hinge,
Damper
Damper
1
2
3
PULLEY, MOTOR, DAMPER
(PULLEY)
(MOTOR)
(DAMPER)
Open the lower cover cap (󳡉) by
using a coin. Turn the drain plug
(󳡊) to pull out the hose.
Unplug the drain plug ( 󳡊 ) , then
the water flows out,
At this time use a vessel
To prevent water from flowing on
the floor. If the water does not flow
any more,turn the pump filter ( 󳡋 )
open to the left.
Take out any foreign material
from the pump filter ( 󳡋 ). After
cleaning, turn the pump filter(󳡋 )
clockwise and insert the
drain plug ( 󳡊 )to the original
place. close the lower cover cap.
󳥎
󳥎 Clean the drain pump filter
1
100
2
3
2
3