Is the water supply shut-off?
Is the tap opened?
When you press both ¡AWash¡Bbutton and ¡ARinse¡B
buttons simultaneously, is the water level frequency
below 40?
Is the inlet valve filter clogged with impurity?
Is resistance of the inlet valve connector
between 2 to 8
k
§
?
Check the voltage between each terminal of inlet
Valve is AV 220~240V.
(Refer to 7-2 TEST MODE)
Is water supplied?
Are replaceptacles correctly connected to the
terminals of inlet valve?
Is detergent put in the correct compartment of
the drawer?
Is the detergent hardened?
Open the tap.
Check the chamber(Air)
and the tube clogged
with impurity.
Clean the filter.
Replace the inlet valve.
Replace PWB assy(Main)
Refer to solution
¡ANO INLET¡B
Check the wiring on the
dispenser.
Put the detergent in the
correct position
PRE+MAIN
MAIN WASH
: Detergent
Clean the drawer.
NO WATER SUPPLY
DETERGENT DOES NOT FLOW IN
MAIN
WASH
SOFTENER
PRE -
WASH