5
PEDESTAL KIT
PEDESTAL INSTALLATION – FINAL INSTALLATION
1
Lower
Raise
2
Locknut
Loosen the locknuts on all 4 leveling feet of
the pedestal until you can turn them with the
wrench. Turn clockwise to raise or
counterclockwise to lower until the pedestal is
level and all 4 feet are solidly against the
floor.
When installing the pedestal on a wooden fl
oor, place the fl oor pads included with your
appliance under the legs of the pedestal. This
will help reduce vibration when the appliance
is operating.
Using the Floor Pads
Securely tighten all locknuts by hand.
NOTE: Noise and vibration may result if
locknuts are not tightened.
Be sure to connect the appliances to all water,
power, or gas lines and draining or venting
connections before operation.
If there is excessive vibration during the first
operation after installation, slightly adjust the
leveling feet.
3
To make sure the appliance is well set on the
pedestal.
Please adjust all four adjustable feet and lock
nuts of the appliance accordingly.
GAP
To Next Page
Loading...
Need help?
General
