45
9. ADJUSTMENT
9-1. BRAKE LEVER ADJUSTMENT
• Shown as in the figure, untighten the adjustment
screw to keep clearance 1.9±0.1mm between
the tip and the brake lever.
And turn on the lock nut then paint it red.
■ CAUTION
• Painting part is adjusted in factory, it does not
need adjusting.
• Adjust the screw properly if the brake doesn't
work during spin.
9-2. KEEPING CLEARANCE
• Keep the clearance about 2.5~3.5mm between
brake lever and P.V link as shown in the figure.
■ CAUTION
• Clutch pulley must be turning to one side when
P.V link is pulling the brake lever.
• Clutch pulley must be turning to the left and the
right when P.V link does not pull the brake
Lever.
9-3. V-BELT ADJUSTMENT
• Adjust the motor pulley by pushing the motor like
arrow
, to make V-belt tension parallel
when pushed at the point of arrow
.
■ CAUTION
• When the V-belt is not properly adjusted, the
motor will not be running or the belt will be
slipping.
CAUTION
CAUTION
CAUTION
To Next Page
Loading...
