50
10-6. Fuse Replacement
1. Be sure to unplug the power.
2. Disassemble back panel (Joined control panel) from
top cover.
3. Take out the fuse holder on the back and open it.
4. Remove fuse from the fuse holder and replace it.
5. Put fuse into the fuse holder and close the fuse
holder. Insert it into original position.
6. Assemble the back panel and then tighten
the screw.
▶ Use the rated fuse. For fuse contact the
nearest service center.
▶ Fuse rating :
250V, 6A (fusing type-For 220~240V)
CAUTION
Fuse
holder
To Next Page
Loading...
