12-10. Spin extraction is not proceeded.
Where, what & how to check? Result of Check Possible Cause How to repair & settle
Motor
1. In the case that the wash motor
does not spin during spin extraction;
1) Check there is motor working
sound,or
2) If there is no motor-working
sound;
① Check frequency of the
pressure switch, under no
load, or
② Check contact defect of the
safety switch, defect of
connection parts and whether
the lid is open if door error is
displayed.
③ Check resistance of the motor.
Drain Motor/Clutch
1. In the case the motor rotates but the
inner tub does not rotates;
1) Check resistance of the drain
motor if the drain motor doesn’t
work,or
2) Check gap between the PV link
and the brake lever if the inner
tub does not rotates while the
drain motor works.
There is motor
working sound.
Less than
26.3kHz
The lid is open.
Defect of
connection part.
Contact defect
of the safety
switch.
∞Ω
∞Ω
Resistance is
normal
The clearance is
less than 2.5mm
or more then
3.5mm
The gap is
normal .
(2.5~3.5mm)
Defect of the
capacitor or
Mechanically
locked.
Defect of the
pressure switch.
Mistake in use.
Coil is open.
Coil is open.
Defect of
connection part
or defect of the
controller.
Assembling defect
of the drain motor
or the clutch
Defect of the
clutch.
Change the capacitor
after checking defect of
capacitor.
check whether the
washing clutch or the
washing tub is blocked
if the motor rotates after
removing the V-belt.
Check whether the
motor is locked if the
motor does not rotates
even though the V-belt
being removed.
Change the pressure
switch
Explain” The lid is close
during operation”
Reconnect the
connectors.
Change the safety
switch.
Change the motor.
Change the drain motor.
Change the controller
after checking
connection parts.
Reassemble the drain
motor or the clutch to
keep the clearance.
Change the clutch.
63
To Next Page
Loading...
