Why is my LG WM2010CW leaking water around it?
If you notice water leaking around your LG washer, the fill hose connection might be loose at the tap or washer. Check the hoses and tighten the connections. Another cause could be clogged house drain pipes. If so, unclog the drain pipe, or contact a plumber if necessary.
What to do if my LG WM2010CW will not turn on?
If your LG washer won't turn on, first ensure the power cord is properly plugged into a grounded outlet. Also, check your house fuse or circuit breaker and reset it if necessary. If the problem continues, consult a qualified electrician to correct a possible circuit overload.
What to do if my LG Washer won’t spin?
If your LG washer won’t spin, make sure the door is closed properly and press the START/PAUSE button. It may take a few moments for the drum to begin to turn or spin after starting a cycle. The washer will not spin unless the door is locked (the DOOR LOCK indicator turns on in the display). If the door is closed and locked and the open door error message is displayed, call for service.
Why does my LG WM2010CW Washer fill with water slowly?
If your LG washer fills with water slowly, make sure the water supply taps are fully open and the water line hoses are not kinked or pinched. Also, clean the water inlet filters. See the Care and Cleaning section. Check another faucet in the house to ensure household water pressure is adequate.
What to do if the LG WM2010CW Washer door will not unlock?
If the door of your LG washer will not unlock, it could be due to a safety lock to prevent burns because the interior temperature is too high. Allow the washer to cool until the DOOR LOCK indicator turns off. Alternatively, the water level might be too high. Allow the washer to complete the programmed cycle, or run the DRAIN & SPIN cycle to drain the water.
How to reduce vibrating noise from my LG WM2010CW?
To reduce vibrating noise from your LG washer: * Ensure shipping bolts and packaging are removed (refer to the Installation Instructions). * Stop the washer and rearrange the wash load if it's unevenly distributed. * Adjust the leveling feet, ensuring all four are firmly on the floor during the spin cycle. * Confirm the floor is solid and doesn't flex. Refer to “Flooring” in the Installation section.
How to fix slow draining in my LG WM2010CW Washer?
If water drains slowly or not at all from your LG washer, ensure the drain hose is free of clogs, kinks, and is not pinched. Also, clean the drain filter. See the Care and Cleaning section.
What to do if my LG WM2010CW Washer display shows an error due to a power failure?
If your LG Washer display shows an error that indicates a power failure has occurred, restart the cycle.
Why is my LG Washer producing excessive suds?
Excessive sudsing in your LG washer is often due to using too much detergent or the incorrect type. Reduce the amount of detergent you're using or switch to a low-sudsing detergent. Make sure to only use detergent with the HE (High-Efficiency) logo.
Why does my LG Washer make a thumping sound?
A thumping sound in your LG washer can be normal with heavy wash loads. However, if the sound continues, the washer is probably out of balance. Stop the washer and redistribute the wash load.
General| Type | Front Load Washer |
|---|---|
| Energy Star | Yes |
| Color | White |
| Steam Washer | No |
| Wash Cycles | 9 |
| Voltage | 120V |
| Control Type | Electronic |
| Water Level Options | Automatic |
| Dimensions | 27" x 39" x 30.25" |
To Next Page
