No. noitanalpxEssecorP
10
Intermittent
spin
• To reach the correct set speed, the motor rotates clockwise and
counterclockwise directions after spin process starts.
• If the water level frequency is lower than 23.0 kHz,
a washer senses suds and starts suds removal process.
11
Rinse
spin
• In this process, the remaining water during washing process is
extracted and the selected speed is kept.
• Removing suds process is in active mode at this cycle.
12
Remaining
spin
• After spin finishes, the drum rotates by remaining spin power until it
stops. Motor power is off.
• This process is overlapped with next process.
13
Rinse water
supply
• Water supply for rinse process.
14
Rinse • Rinsing process.
15 Last
drainage
• After spin finishes and power is not supplied to motor, the drum
rotates by remaining spin power.
• If rinse hold is selected, the drainage is not proceeded after rinse
finishes.
16
Disentangling • The same as item 9.
17
Intermittent spin
• The same as item 10.
18
19
20
21
22
Main spin1 • The same as item 11.
Main spin2 • At the end of a main spin, the spin speed will reach the selected rpm.
Remaining spin • The same with item 12.
Disentangling • After spin finishes, disentangling starts to remove unbalanced
laundry.
End • After ‘end’ signal is displayed, it stays for 8 seconds and power is
automatically turned off. (Auto type door switch)
• After door switch is off, end signal is displayed in the case of
manual type and it takes around 2 minute to turn off door switch.
4:
Copyright © 2016 - 2017 LG Electronics Inc. All rights
reserved. Only training and service purposes.
To Next Page
Loading...
Need help?
General