LG WT-H550 - Control Panel Functions

15
WASHING CONDITION INDICATOR (OPTION)
•This only operates in FUZZY Program.
* While the sensor is detecting the washing conditions, the LED flashes green, orange
and red in turn. And, after detecting, the LED lights a specific color according to the detected condition as
follows:
* If the current washing condition (Detergent quantity, Water Temperature, water quality, etc.) is determined as
better than the standard one, it optimizes the algorithm to save the energy by decreasing washing time/strength,
and the LED automatically turns to red.
* If the current washing condition is determined as worse than the standard one, it optimizes the algorithm by
increasing washing time/strength, and the LED automatically turns to orange.
If the current washing condition is determined as equal to the standard one, the algorithm has no change and the
LED turns to green.
zr
POWER(AUTO OFF)
BUTTON
• Use to turn the power on or off.
• Push again and power goes on or off
• The power goes off automatically about
10 seconds after the wash is finished.
DELAY START (RESERVATION) BUTTON
• Use to set a delayed finishing time.
• The time increases when the button
is pushed.
• The following settings are indicated
as the button is pushed 3 M ► S ►
... 11 ► 12 ► 14 ► 16 ► ...46 ^48
► 3 HOUR.
• To cancel delay time, turn the power
switch off.
(refer to page 24)
PROGRAM BUTTON
• Use for selecting wash program.
• This button allows you to select 8
different programs for different kinds of
laundry.
• program selections light up in sequence as
follows: FUZZY ► WOOL> QUICK
WASH ► J EANS ► E COCOTTON ►
SILENT ► FAVORITE ► T UBCLEAN
► FUZZY etc. Select the desired
program by pressing the button.
START/PAUSE BUTTON
• Use to start or pause the
washing process.
• The washer will turn off
automatically if left in
Pause mode for longer than
10 minutes.
* Because the detecting ability of the sensor may be decreased over time, a tub clean cycle periodically is recommended.
(refer to page 21)
* Even if the water level or the water temperature are changed by the user in FUZZY Program,
the sensor will still work. The sensor algorithm may differ according to models.
* The control panel may differ according to different models.
* For best washing results, We recommend to mix dry detergent with warm water.
Before
Starting
to
Wash