LG WT-H550 - Page 29

29
Screw Type
Attach the water supply hose to the tap.
Push the water supply hose up so that the rubber
packing within the hose can adhere completely to
the tap.
Connect the water supply hose to the tap.
Connect the water supply hose to the tap and then
tighten it by screwing it to the right.
Do not over tighten by using multi grip type tools. Hand tighten only.
Check water leakage.
After connecting the hoses at the tap and at the machine,
open the tap to check for any water leakage.
If water is leaking, check for cross threading or securely tighten with a towel.
Connecting Water Supply Hose to the machine
• Connect the water supply hose to inlet valve of
the washing machine, and then lock it by turning
the hose connecting part.
Check to see if there is a rubber seal inside the
connector.
Hose connector
Rubber seal
Installation