LG WT-H9506 - Page 41

ERROR DECISION CAUSE FOR ERROR
BASIS OCCURRENCE
REMEDYERROR
• LID is opened in the
course of
intermittent spin,
normal spin or
processing
reservation.
• SIGNAL
continuously ringing.
•
Water Pressure
Switch is off.
• AC motor has a bad
connection or failed
• In the second QC
MODE, the following
message is
displayed.
DOOR
OPEN
PRESSURE
SENSOR
AC, MOTOR
(CLUTCH
MOTOR)
LAUNDRY
AMOUNT
SENSOR
• Lid is opened during intermittent
spin or normal spin?
• Lid is opened while processing
reservation?
• Connector to the S.F S/W or
VIOLET(VL) 2 PIN
CONNECTOR to the P.W.B ASM
has bad connection.
• S.F S/W or BALL PRESSURE
SENSOR is bad or bad contact.
• Is placed magnetic in LID-B?
• Connector the Ball Pressure
Sensor(Pressure Switch) or
BLUE(BL) 3 pin connector to
P.W.B ASM has bad connection.
• Ball Pressure Sensor
(Pressure Switch) is bad.
(In the initial state of QC TEST
MODE, the number on the
DISPLAY is less than 63 or
more than 70)
• Check the connections at the AC
motor and at the WHITE 6-pin
connector at the main board.
Test AC motor or coupling to
determine it is not detective.
• Check MOTOR, CLUTCH,
V-BELT, CONDENSOR.
• Check over all connectors if
they have bad connection.
• Closed the lid.
• Closed the lid.
• Correct the connector contact.
• Check and replace S.F S/W or
BALL PRESSURE SENSOR.
• Change the LID-B.
• Correct the connector contact.
• Replace Ball Pressure
Sensor(Pressure Switch).
• Reseat the connector.
Replace the AC motor if
necessary.
Replace the coupling or Clutch
housing if necessary.
•
• Adjust or replace those parts.
• Correct the connectors contact.
Clutching is failed
-.Coupling get out of
gear.
-.Coupling is broken.
•
•
•
40