OW TO USE
CYCLE MODIFIER BUTTONS (COnt.)
RINSE + SPIN
Select this option to rinse and spin a load
separately from a regular cycle. This can be
helpful in preventing fresh stains from setting in
fabrics.
• You can change rinse temperature and spin
speed by pressing WASH/RINSE and SPIN
SPEED respectively.
A Press the POWER button to turn on the
washer.
e
Press the SPECIAL USE button until the
RINSE+SPIN indicator light is lit. (The cycle
light will turn off.)
O Press the START/PAUSE button the
to start
cycle. The washer will start automatically.
SPIN ONLY
This button activates the Drain & Spin cycle to
drain and spin.
Press the Power button to turn on the
washer.
O Press the SPECIAL USE button until the
SPIN ONLY indicator light is lit.
O Press the START/PAUSE button to start the
cycle. The washer will start automatically.
SOAK
Allows the consumer to remove stains more
thoroughly by specifying additional time for the
clothing to soak during washing. At the end of
SOAK, the wash cycle will be started without
drain.
Cycle time will be increased by 30 minutes.
It is normal that washer do weak agitation
during SOAK cycle.
NOTE: You cannot select the SOAK option in the
TUB CLEAN cycle.
STAIN CARETM
STAIN CARE TM may be selected as an option with
HEAVY DUTY, Co-IrON/NORMAL and TOWELS
cycles.
Wash only small loads for optimum fabric care.
(less than 8 Ibs.)
Press the POWER button to turn on the
washer.
O Press the SPECIAL USE button until the
STAIN CARE TM indicator light is lit.
Press the START/PAUSE button to start the
cycle. The washer will start automatically.
NOTE: if you select STAIN CARET% the
COLDWASH TM option is not available.
21
To Next Page
Loading...
