30
⑤ Remove the six screws securing the rotor.
⑥ Check the position of the snap ring, being cure it
faces the rotor and stator.
⑦ To keep from dropping the stator, loosen the six
bolts almost all the way; then hold the stator in one
hand while removing the bolts with the other.
⑧ Be careful during removal and replacement to avoid
cutting, nicking, or pinching any of the wires. This
could cause a short or electrical noise in the
machine.
④ Disconnect the hall sensor and stator
connection before removing the stator in the
subsequent step.
⑧ Remove the screws that secure the water guide.
To Next Page
Loading...
