Setting up
11
Connect the speaker cables to the player
Cables from the left-hand speaker connect to the terminal
marked L (left) + (plus) and - (minus). Cables from the right-
hand speaker are connected to the terminal marked R (right)
+ (plus) and - (minus).
To connect the cable to the player, press each of the four
square plastic finger pads on the rear of the player.
The connector will open ready to receive a cable.
Put the battery in the remote control
Make sure that the + (plus) and - (minus) on the
battery (size AAA) match those on the remote
control.
22
Fit the AM loop aerial to its stand
Connect the AM loop aerial to the player.
33
Connect the FM aerial
The reception will be at its best when the two loose
ends of the aerial are in a straight line and horizontal.
44
Plug the power plug into a wall socket
To Next Page
Loading...
