LHZ TEI 1 – manual Thermostat
Each radiator can be controlled individually by simply operating the TEI 1 thermostatic
control knob located on the side panel of the radiator. This can be set to meet the temperature
requirements of the room by simply turning the TEI 1 knob until you reach your desired room
temperature.
TEI 1 (Manual Thermostat) – this thermostat is located on the side of the radiator and can
be manually adjusted to regulate the temperature within the room.
When the overall system reaches the set temperature on the room thermostat, the power
supply is disabled to all radiators, however the radiator will continue to radiate the heat that
has been stored within the radiator. When the room temperature falls below the set
temperature on the room thermostat, the power will automatically be enabled, this will allow
the radiators to maintain the required temperature in each room.
Alternatively you can request a higher temperature on the room thermostat which will also
enable the more power to the radiators.
Each radiator has a Thermostat Sensor installed on the underside of the radiator. This is
designed to determine the room temperature.
Note - the Thermostat Sensor should protrude between 3cm – 5cm from the locating screw.
To Next Page