Unpacking & Inspection 1-1
1
1
Unpacking &
Inspection
®
C
O
2
/H
2
O
A
N
A
LY
Z
E
R
M
o
d
e
l
L
I
-
6
2
6
2
R
E
A
D
Y
Z
E
R
O
S
P
A
N
C
O
2
O
N
O
F
F
F
U
N
C
T
I
O
N
E
E
X
,
E
N
T
E
R
↓
↑
4
5
6
7
8
9
C
0
.
2
3
1
Z
E
R
O
S
P
A
N
H
2
O
1.1 What's What
This procedure should be followed if you have just taken delivery on your
LI-6262. Check the packing list to verify that you have received everything
that was ordered and that you have also received the following items:
● Calibration Sheet - This data sheet contains a copy of the calibration
information entered into the analyzer at the factory. Keep it in a safe
place for future reference, or in case calibration data must be re-entered.
● Console Command Sheet - A quick reference card for entering console
commands via the LI-6262 keypad or from an external terminal.
● Spare Parts Kit - This kit contains replacement parts for your LI-6262.
As you become familiar with the analyzer you will learn which items to
keep close at hand and which items can be stored away.
● External Scrubber and Desiccant Tube - This tube is used during
normal operation. Several spare gaskets and adhesive disks have been
included for future use.
● 1000-90 Data Communications and Utility Software - This software
can be used to communicate with an IBM PC/XT/AT/PS2 or
compatible. The software is provided on 3 1/2 inch diskettes.
● RS-232C Cable - (Part #392-02874) DTE to DCE, used to connect the
LI-6262 (DCE) to a DTE device such as an RS-232C printer.
● RS-232C Gender Changer - (Part #392-02977) Female-to-female
gender changer, used to connect the RS-232C cable to most computers.
To Next Page
