16
6. Wait until Apply Sample Symbols
appear in Display. Keep Strip in
Meter until testing is finished.
Note: If Strip is removed before testing
is finished, an error message
appears. Release and discard
old Strip. Use new Strip for
testing.
7. Turn Control bottle upside down.
Squeeze one drop of Control onto
a clean tissue. Wipe off bottle tip.
8.
Gently squeeze a Control drop onto
a small piece of unused aluminum
foil or clear plastic wrap. Dispose
after use.
9.
With Strip still in Meter, touch edge
of Sample Tip to drop of Control
and allow drop to be drawn into
Strip. Remove Strip from drop when
Meter beeps.
10.
Dashes appear across the Display to
show Meter is testing.
Note: If Meter does not beep or begin
testing soon after drawing up sample,
(dashes appear in Display), release and
discard Strip. Repeat test with new Strip.
If problem persists, see Troubleshooting.
Apply Sample
Symbols
TR_OB_GutsENG_E4LBT04.qxd:TT_OB_GutsENG.qxd 9/30/08 10:29 AM Page 16
To Next Page
Loading...