Liberty System - Meter Setup: Configuring Time and Date; Entering Meter Setup Mode; Setting the Hour and AM;PM Indicator

Meter Set Up
Note: If the Meter turns off at any
time during Set Up, go back
to Step #1 under Meter Set
Up and begin again.
1. Press and hold “ S ” until tone
sounds (around 30 seconds).
Release “ S ”. The full Display
appears and the Meter goes into
Set Up.
Set Time/Date
2. The hour flashes. To change, press
“ + ” or “ - ” on top of the Meter to
select the hour. Like many alarm
clocks, to set "AM" or "PM", scroll
through the hours until "AM" or
"PM" appears in the Display.
Press “ S ” to set.
Note: "AM" or "PM" does not display if Meter is
factory set to 24-hour clock.
3. The minutes flash. To change, press
“ + ” or “ - ” to select the minutes.
Press “ S ” to set.
23
TR_OB_GutsENG_E4LBT04.qxd:TT_OB_GutsENG.qxd 9/30/08 10:29 AM Page 23