10
Operating the V-Comb
1. To change the combing angle, hold and push down the
knobs on both sides of the combing unit and adjust the
angle of the teeth. Release both knobs to secure in place.
Two set positions are available:
straight position or raking position.
2. Hair should be clean, conditioned and dry. Brush
thoroughly to remove any knots.
Separate the hair into sections, no wider than the teeth,
using hair clips. Switch on the V-Comb to begin treatment.
Always start from the nape of the neck and work your way
up, one section at a time, combing the top of the head
last. Ensure you are holding the comb the right way up.
Straight position Raking position
To Next Page
Loading...
