Need help?Do you have a question about the Life Fitness Chest Press and is the answer not in the manual?
General| Brand | Life Fitness |
|---|---|
| Model | Chest Press |
| Category | Home Gym |
| Language | English |
Loosely assemble front and rear braces to the tower using specified bolts, washers, and nuts.
Loosely assemble the seat frame to the front and rear braces using specified bolts, washers, and nuts.
Loosely assemble the top brace to the seat frame and tower using specified bolts, washers, and nuts.
Insert pivot shaft, spacer, and bearings into workarm, then secure workarm to front brace.
Assemble output cam, plate, and ring using specified bolts and washers.
Assemble rear and front shrouds to the tower using specified bolts and washers, ensuring tabs are engaged.
Secure the output cam assembly to the tower hub using a specified bolt, washer, and plate.
Attach the cam guard to the front shroud using specified Phillips screws.
Attach the seat pad to the seat frame using specified bolts and washers.
Attach the back pad to the seat frame using specified bolts and washers.
Assemble M10 hex jam nut, rod end bearing to the cable end.
Loosely assemble the rod end bearing of the cable to the workarm using bolt, spacer, washer, and nut.
Route the cable around the pulley, over the cam guard, and through the output cam assembly.
Attach the output cam cover plate to the output cam assembly using specified bolts and washers.
Place unit, check stability, and adjust feet using shims if necessary.
Install hole plugs in all open bolt holes.
To Next Page