Need help?Do you have a question about the Life Fitness Squat and is the answer not in the manual?
General| Brand | Life Fitness |
|---|---|
| Model | Squat |
| Category | Home Gym |
| Language | English |
Loosely attach the platform frame to the tower using specified bolts, washers, and nuts.
Loosely attach the center brace to the platform frame using specified bolts, washers, and nuts.
Loosely attach the upright to the center brace and the upper brace to the upright and tower.
Securely tighten all previously installed bolts and nuts.
Install pivot shaft, long spacer, bearings, and short spacers into the workarm's pivot housing.
Assemble the workarm to the upright using specified bolts and washers, then tighten securely.
Assemble output cam, output plate, and output ring using specified bolts and washers.
Attach rear and front shrouds to the tower using specified bolts and washers.
Secure the output cam assembly to the tower hub using a bolt, washer, and plate.
Attach the cam guard to the front shroud using specified Phillips screws.
Assemble the hex jam nut and rod end bearing onto the cable end.
Loosely assemble the cable rod end bearing to the workarm using specified hardware.
Route cable over cam guard and output cam assembly, secure with retaining plate and jam nuts.
Attach the output cam cover plate to the output cam assembly using specified hardware.
Place unit, check stability, and adjust feet using shims or leveling bolts.
Attach the platform to the platform frame using specified bolts and washers.
Install hole plugs into all open bolt holes for a finished look.
To Next Page