Page 5
Check that the distance “C” on the gate support structure is no greater than the value given in the table below. If the distance is higher than this value,
it is necessary to intervene by making a niche in the structure to obtain the indicated value. This is to avoid the linear operator colliding with the edge of
the structure during closure. The niche must be made in the area in which the linear operator is to be installed and it must have a height such as to allow
operator passage.
2.3 Rear and front bracket positioning
the distances A, B and C.
established position.
a. Take the leaf to the closure position, resting it against
the closure stop plates.
68
The value of
E
must be just lower (10 mm) than
D
(2) with a clamp.
OP324 UNI OP524 UN
Ω
OP3 - OP3L - OP3 UNI – OP3L UNI – OP324 OP5 – OP5L – OP5UNI – OP5L UNI – OP524
A -mm B -mm CMAXmm D*mm A -mm B -mm CMAXmm D*mm
1
1
1
2
2
E
OP3= 745
E
OP5= 895
68
1
A
B
D
C
Ω
Ω
1
2
E
A
A
B
B
C
OP3 - OP3L - OP3 UNI – OP3L UNI OP5 – OP5L – OP5UNI – OP5L UNI
OP324-OP324UNI OP5-OP5L–OP524 UNI
E
745 mm 895 mm
OPTIMO 3
OPTIMO 5
C
To Next Page
Loading...
Need help?
General
