7
ANYWAY
®
technology
LIFESAVER
®
jerrycan has been
designed to work at any angle
1
and on any axis. It incorporates
ANYWAY
®
technology. This means
that in effect it will work in any
position. When the level of the
water in the jerrycan gets low,
turning it on its side
2
will improve
the flow rate.
Transport
When taking your LIFESAVER
®
jerrycan on
an aeroplane ensure that it is completely
drained of water and that it is packed
securely within your luggage. Protect from
freezing. Ensure that the jerrycan is de-
pressurised before your trip.
Before you undertake any trip…
It is important that you follow these few
simple steps:
• Ensure that the cartridge is correctly
and firmly in place. (‘How to install or
replace a LIFESAVER
®
jerrycan UF
cartridge’ - page 12)
• Check the pump is working smoothly
and add a small amount of silicone
grease (provided) to the piston head as
required. (‘Maintenance and care’ -
page 9) Failure to do this will result in
the premature wearing of the o-ring.
• Perform a membrane integrity check.
(Membrane integrity check - page 16)
• If you think that the area you are visiting
may have chemical contamination in
the water you should install a
LIFESAVER
®
activated carbon tap
before your trip. This will avoid the risk
of performing this operation in the field.
CAUTION
Always keep the tap cap firmly
screwed on when in the field.
CAUTION
DO NOT remove cap unless
changing the activated carbon
filter tap or the LIFESAVER
®
cartridge and then only after
following instructions (How to
install or replace a LIFESAVER
®
jerrycan UF cartridge - page 12).
CAUTION
When removing the pump
unscrew ¼ turn and allow any
pressurised air still within the
jerrycan to escape. Failure to do
this could result in the pump being
forced out of the jerrycan at speed
and could cause serious injury.
USING YOUR JERRYCAN
1
2
To Next Page
Loading...
