20
BLOOD GLUCOSE TESTING
2. Cover the exposed lancet tip
Before removing the lancet, place the lancet protective
cover on a hard surface then push the lancet tip into the
flat side of the disk.
Removing the used lancet
NOTE: This lancing device has an ejection feature, so you do
not have to pull out the used lancet.
1. Remove the lancing device cap
Remove the cap by rotating it
and then pulling it straight off
the device.
3. Eject the lancet
Holding the lancing device directed
downwards, push the slider
forward until the lancet comes out
of the lancing device. If the lancet
fails to eject properly, cock the
device then push the slider control
forward until the lancet comes out.
To Next Page
Loading...
