2524
Step 1: Unpacking Treadmill
A. Cut packaging straps and
remove.
B. Remove the box top.
C. Remove small parts and
packaging material and
unwrap parts.
D. Cut the corners of the bottom box and remove all packaging material to
begin assembly. The treadmill can be assembled in the box. No need to
pick the treadmill up to remove it from box.
E. Cut plastic shipping strap holding deck frame to base.
Step 2: Upright Post Attachment
A. Carefully fold the uprights
with handlebars up into the
upright position.
B. Carefully lay handlebars down
as the uprights are brought
up into position. This will
protect against any accidental
damage to wires coming up
through the upright into the
handlebars.
C. Align the holes in the lower
portion of the upright with the
threaded holes in the frame.
D. Install the four M10 x 55L
bolts (9) and M10 washers
(10), two in each upright. The
best way to handle this is to
loosely install all four bolts
and washers and then tighten
once all bolts are installed.
Assembling Your Treadmill
Step 3: Upright Post Cover Attachment
A. Install the left upright cover
(4) by sliding the front of the
cover around the upright and
centering or aligning the cover
on the upright.
B. Install the M4 x 10L screw (13).
C. Repeat steps A and B for the
right upright cover.
Step 4: Handlebar Attachment
A. Place the M8 x 100L bolt
(11) and M8 washer (12)
through the left handlebar
and into the uprights being
careful not to damage any
wires running through the
handlebar. Repeat for the
right handlebar.
B. Loosely thread both bolts
into the upright prior to
tightening.
C. Fully tighten both handlebar
attachment bolts.
Assembling Your Treadmill
To Next Page
Loading...
