BEFORE YOU BEGIN
Thank you for selecting the innovative LIFESTYLEFP 310 stepper. Stepping is one ofthe most effective
exercises known for increasing cardiovascular fitness, building endurance and toning the entire body.
The LIFESTYLER 310 blends advanced engineering with contemporary s_ling to let you enjoy this
invigorating exercise in the comfort and privacy of your own home. Feel better, look better and be
healthier in just a few minutes a day.
For your safety and benefit, read this manual carefully before using the stepper. If you have
additional questions, please call our Customer Service Department toll-free at 1-800-999-3756,
Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). Tohelp us assist you,
please note the product model number and serial number before calling: The model number is
831.285750. The serial number can be found on a decal attached to the stepper (see the front cover of
this manual for the location).
ASSEMBLY
Place all parts of the stepper in a cleared area of the floor. Remove all packing materials, except the
tape securing the sensor wire to the top of the upright (see assembly step 5). Do not dispose of the
packing materials until assembly is completed. Assembly requires a hammer and a phillips
screwdriver (not included).
1. Make sure that there is an Endcap (15) on each end of the
Stabilizer (21). Note: The Endcaps may need to be rotated
so that they are flat against the floor.
Attach the Stabilizer (21) to the saddle on the Base (20)
with the two M8 Carriage Bolts (22) and M8 Nylock Nuts
(23).
1
15
21
3
To Next Page
Loading...
