2._ Apply grease to the shaft on the Base (20).
Apply grease around the hole in the right side of the
Right Pedal (18), and around the outer edge of the left
side of the Right Pedal. Slide the Right Pedal onto the
right end of the shaft on the Base (20).
Apply grease to the Left Pedal (19) inthe same manner.
Slide the Left Pedal onto the left end of the shaft on the
Base (20).
o
°
Peel the backing off the two Pedal Covers (17). Press one
Pedal Cover onto the Left Pedal (19). Press the other
Pedal Cover onto the Right Pedal (18).
Peel the backing off the two Bumpers (36). Press a
Bumper onto the underside of each Pedal (18, 19).
Attach a 2mm Washer (14), an Endcap (15) and a Lock
Washer (32) to the right side of the Base (20) with an M10
Screw (9). Attach the other Endcap (15) in the same
manner. Do not overtighten the Screws; the Pedals (18,
19) must pivot freely.
Attach the Magnet Mount (28) to the Right Pedal (18) with
the M5 Self-tapplng Screw (33) (see the inset drawing).
Set the Upright (6) on the four welded bolts in the Base
(20). Make sure that the Upright is angled in the direction
shown. Attach the Uprightto the Base with four M10
Nylock Nuts (24).
2- =Apply
19'G /ase AGPrePlaYse
3
19 18
15
14
32
17 9
i tl
°
2O
•
5. Remove the four M4 Screws (30) and the two M10 Plate
Screws (25) from the Handlebar Plate (2). Backthe M5
Screw (31) out of the lower end of each Handlebar (4, 5).
Insert the Left Handlebar (4) intothe Handlebar Plate (2).
Replace the two M4 Screws (30) in the left side of the
Handlebar Plate. Do not fully tighten the Screws yet.
Insert the Right Handlebar (5) into the Handlebar Plate
(2); Do not replace the M4 Screws (30) in the right side of
the Handlebar Plate yet.
5
To Next Page
Loading...
