Lifetime 2119 - Page 10

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
10
SEC
BAE
BAD
**TWO ADULTS REQUIRED FOR THIS STEP**
**TWO ADULTS REQUIRED FOR THIS STEP**
SEC
1.9
SEC
1.10
0LACETHE*#HANNELONTOTHETUBESOFTHETable Leg Assembly (BAE)ASSHOWN4ILTTHE"ENCHANDINSERTTHEOTHER
*#HANNELATTACHEDTOTHE"ENCHONTOTHE4ABLE,EG!SSEMBLY
0LACETHE*#HANNELBACKINTOTHE"ENCH%NSURETHE*#HANNELlTSINTOTHEGROOVEINTHE"ENCH)NSERTTHE
3CREWSBACKINTOEACHHOLEINTHE*#HANNEL!TTACHTHE3CREWINTHEMIDDLEOFTHE*#HANNELlRST5SETHESAME
HOLESINTHE"ENCHFROMWHICHTHE3CREWSWEREREMOVED4IGHTENTHE3CREWSONLYUNTILTHEHEADOFTHE3CREW
MAKESCONTACTWITHTHE*#HANNELRepeat Steps 1.8 through 1.10 to attach the other Bench.
USE HARDWARE TAKEN FROM J-CHANNEL
1
1.
Note: Do not put the J-Channel on upside down. Refer to the installed J-Channel for the correct orientation.
!