Lifetime 2119 - Page 9

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
9
SEC
BAD
BAD
J-Channel
SEC
1.7
SEC
1.8
)NSERTTHETable Leg Assemblies (BAE)INTOTHEBrace Assemblies (BAF)"EFOREINSERTINGTHE,EGSENSURETHEPLASTIC
LOCATINGPININTHE"USHINGSTICKSTHROUGHTHEHOLEINTHE"RACES!SSEMBLIES$ETAIL%NSURETHE0USHBUTTONS
INTHE4ABLE,EG!SSEMBLIESSNAPINTOTHEHOLESINTHE"RACE!SSEMBLIES)FTHE0USHBUTTONSAREFACINGTHEWRONG
DIRECTIONREINSERTTHEMCORRECTLY
2EMOVEONE*#HANNELFROMA Bench Assembly (BAD)BYREMOVINGTHE3CREWSTHATHOLDTHE*#HANNELINPLACE
BAE
BAE
BAF
BAF
Tubes must face
each other
Detail 1
Bushing
BAF
REMOVE HARDWARE FROM J-CHANNEL
1
1.
Push-
Button
Note: Save the Screws for use later in the assembly.
!