69
TOOLS AND HARDWARE REQUIRED / OUTILS ET QUINCAILLERIE REQUIS / INSTRUMENTAL Y HERRAJE REQUERIDOS
X SECTION 10 (CONTINUED) / SECTION 10 (SUITE) / SECCIÓN 10 (CONTINUACIÓN)
ADZ (x21)
ADZ
• Set the end of the Center Truss onto the notch in the Front Gable as shown.
• Mettez l’extrémité de la ferme centrale dans l’encoche dans la pignon
avant comme illustré.
• Coloque el extremo de la cercha central en la muesca en la fachada
delantera como se muestra.
10.24
10.25
Note: Tighten this Nut and Bolt now.
Remarque : Serrez cette vis et l’écrou maintenant.
Nota: Apriete este perno y la tuerca ahora.
!
• Attach the two center, rear Roof Panels
(AGQ) using only one Roof Support per
Panel.
• Attachez les deux panneaux de toit (AGQ)
arrières centraux en utilisant un seul
support de toit pour chaque panneau.
• Sujete los dos paneles de tejado (AGQ)
traseros centrales usando sólo un soporte
de tejado por panel.